2010.Gearbox
-
Assembly #8. The brand new drive cone is in place. Previous owner apparently put the old cone back side front at least once, but
-
Assembly #9. The drive cone, thrust collar B and needle bearing inner race are in place.
-
Assembly #10. Reverse gear, thrust collar A, roller bearing.
-
Assembly #11. Rear oil seal. Yanmar part# 177088-02961.
-
Assembly #12. Front oil seal. Yanmar part# 24413-254008.
-
Assembly #13. All shafts are back to the housing.
-
Assembly #14. Mounting flange is attached to the clutch housing. Bolts and washers are new. Non-drying liquid packing (got it fr
-
Assembly #15. Output shaft coupling and O-ring (not visible on the photo) are in place, nut is tightened and calked.
-
Shifters, old and new - find the difference. ;-) Old shifter had depletion of about 2 mm.
-
The gearbox put together. Note the red non-drying liquid packing between the mounting flange and the housing.
-
The gearbox from the mounting flange side. Ready for installation.
-
The gearbox is installed, shafts are aligned, coupling bolts are tightened. I had to detach the engine from the mounting places